National Instruments NI 781xR User Manual download pdf (Page 39)

Using the SCB-68

Shielded Connector Block

This appendix describes how to connect input and output signals to the

NI 781xR with the SCB-68 shielded connector block.

The SCB-68 has 68 screw terminals for I/O signal connections. To use the

SCB-68 with the NI 781xR, you must configure the SCB-68 as a

general-purpose connector block. Figure C-1 illustrates the

general-purpose switch configuration.

Figure C-1. General-Purpose Switch Configuration for the SCB-68 Terminal Block

After configuring the SCB-68 switches, you can connect the I/O signals to

the SCB-68 screw terminals. Refer to Appendix B, Connecting I/O Signals,

for the connector pin assignments for the NI 781xR. After connecting

I/O signals to the SCB-68 screw terminals, you can connect the SCB-68 to

the NI 781xR with the SH68-C68-S shielded cable.

S5 S4 S3

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

No comments

National Instruments NI 781xR User Manual Page 39