National Instruments PCIe-836x User Manual download pdf (Page 12)

Hardware Installation

This chapter explains how to install the MXI-Express hardware.

Hardware Installation

The following are general instructions for installing the MXI-Express

cards. Consult your computer user manual or technical reference manual

for specific instructions and warnings.

Note The software for your MXI-Express kit is included with the current NI driver CD,

and is installed with the PXI platform software included as part of NI-VISA and other

NI driver software products.

Installing an NI PCIe-836x

1. Power off your computer, but leave it plugged in while installing the

NI PCIe-836x. The power cord grounds the chassis and protects it from

electrical damage while you install the card.

Caution To protect both yourself and the computer from electrical hazards, your computer

should remain off until you finish installing the NI PCIe-836x.

Note If you are installing a low-profile PCIe-8361 into a low-profile slot, you must

replace the bracket with the low-profile bracket included in your kit. First, remove the

two hexagonal jack screws on either side of the connector. Then remove the two screws

mounting the bracket to the card. Exchange the brackets, replace the two mounting screws,

and replace the two hexagonal jack screws.

2. Remove the top cover or access port to the PCI Express bus.

3. Select any available PCI Express expansion slot (x1 or wider).

Note The BIOS or motherboard may not support the NI PCIe-836x in a slot intended for

a graphics card.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

No comments

National Instruments PCIe-836x User Manual Page 12