National Instruments PXI-8184 User Manual download pdf (Page 26)

Chapter 2 Installation and Configuration

The NI PXI-8184/8185 controller includes the following LabVIEW RT

configuration switches:

• Switch 1—Boot LabVIEW RT: Set this switch to ON to boot

LabVIEW RT.

• Switch 2—Boot Safe Mode: Set this switch to ON to boot

LabVIEW RT into safe mode to reconfigure TCP/IP settings and

to download or update software from a host computer. This switch

overrides the behavior of Switch 1. Booting the controller into safe

mode does not start the embedded LabVIEW RT engine. After

changing the settings or software, reboot the controller with this switch

OFF to resume normal operation.

• Switch 3—Disable Startup VI: Set this switch to ON to prevent

VIs from automatically running at startup if the controller becomes

inaccessible because of a startup VI.

• Switch 4—Reset IP Address: Set this switch to ON to reset the

IP address to 0.0.0.0 and other TCP/IP settings to their defaults.

Use this switch if moving the controller to a different subnet or if

the current TCP/IP settings are invalid.

Figure 2-4 shows the location of the LabVIEW RT configuration switches.

The switches are shown in the OFF position.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

No comments

National Instruments PXI-8184 User Manual Page 26